Powered Handcycles - Quad Viper

The Quad Viper has the same top class spec as the regular Viper except for the addition of the very ingenious Quad Bars.

The Quad Bars have been designed by team Hybrid to replace the gripping squeezing motion used to operate convential brakes.

With the Quad Viper all that is needed is a gental push on the specially designed bars.

---

Powered Hub

The Quad Viper is powered by the Heinzmann™ electronic hub which is renowned for its reliability and ruggedness.

All Heinzmann motors are built to the same basic plan. The motor is spoked directly into the rim, and can be fitted to any size from 16” to 28”. The motor is 36V, 200W, 43Nm.

---

Pack / Controller

The Saft power module is a very sophisticated piece of equipment. The module contains the Ni-MH batteries, a very clever battery monitor, a very sophisticated electronic controller with numerous safty features and a full BMS (Battery Management System).

Saft power modules generally last well over 600 cycles, thats two years of daily use. The non reversable decline is generally down to the quality of the cell, the Saft cells are generally acknowledged to be the best made, so last longer than the cheaper brands.

---

Controller

A pulse-width controller, controlled by the throttle on the handlebar. The throttle has an on/off switch and light, and there's a key switch on the Power Pack.

The controller also has safety features to protect you and other parts of the system: it monitors the temperature of the motor at all times, and it monitors every cell in the pack - if anything goes wrong (very rare!) it cuts out to protect you and everything else.

---

Cables and Connectors

To stand up to years of use in all weathers, we only use the toughest cables and connectors available.

---

Docking System

The Viper power cycle can be connected to most rigid wheelchairs via a docking system that is permanently mounted under the wheelchair. It is lightweight, and adds approximately one kilogram to the weight of the chair. Once connected it takes only seconds to dock on.

The rear of the docking system is bolted to either the back axle or a bar going across the back of the chair. The front is bolted to the bar underneath the front of the seat. Some chairs do not have this bar, Kuschall for example. In this case we tailor a bar to the chair, which is then bolted on using the existing holes.